ISO 228-1:2000

Pipe threads where pressure-tight joints are not made on the threads - Part 1 : dimensions, tolerances and designation

This part of ISO 228 specifies the requirements for thread form, dimensions, tolerances and designation for

fastening pipe threads, thread sizes 1/16 to 6 inclusive. Both internal and external threads are parallel threads,

intended for the mechanical assembly of the component parts of fittings, cocks and valves, accessories, etc.

These threads are not suitable as jointing threads where a pressure-tight joint is made on the thread. If assemblies

with such threads must be made pressure-tight, this should be effected by compressing two tightening surfaces

outside the threads, and by interposing an appropriate seal.

NOTE 1 For pipe threads where pressure-tight joints are made on the threads, see ISO 7-1.

NOTE 2 ISO 228-2 gives details of methods for verification of fastening thread dimensions and form, and recommended

gauging systems.

To comply with a standard, you need to quickly understand its issues in order to determine its impact on your activity.

The Requirements department helps you quickly locate within the normative text:
- mandatory clauses to satisfy,
- non-essential but useful clauses to know, such as permissions and recommendations.

The identification of these types of clauses is based on the document “ISO / IEC Directives, Part 2 - Principles and rules of structure and drafting of ISO documents ”as well as on a constantly enriched list of verbal forms.

With Requirements, quickly access the main part of the normative text!

COBAZ is the simple and effective solution to meet the normative needs related to your activity, in France and abroad.

Available by subscription, CObaz is THE modular solution to compose according to your needs today and tomorrow. Quickly discover CObaz!

Request your free, no-obligation live demo

I discover COBAZ