NF EN ISO 15085

NF EN ISO 15085

July 2003
Standard Current

Small craft - Man-overhead prevention and recovery

ISO 15085:2003 specifies the design as well as the construction and strength requirements for safety devices and arrangements intended to minimize the risk of falling overboard, and requirements to facilitate reboarding. It describes means which can be used individually or combined to achieve these objectives, and applies to small craft of up to 24 m length of hull. ISO 15085:2003 is not applicable to the following boat types: aquatic toys;canoes, kayaks, or other boats with a beam less than 1,1 m;personal watercraft, covered by ISO 13590;inflatable boats with a hull length of less than 8 m, covered by ISO 6185.

View the extract
Main informations

Collections

National standards and national normative documents

Thematics

QSE, Gestion des risques et SST, Sécurité

Publication date

July 2003

Number of pages

32 p.

Reference

NF EN ISO 15085

ICS Codes

13.200   Accident and disaster control
47.080   Small craft

Classification index

J95-050

Print number

1 - 10/11/2003

International kinship

European kinship

EN ISO 15085:2003
Sumary
Small craft - Man-overhead prevention and recovery

ISO 15085:2003 specifies the design as well as the construction and strength requirements for safety devices and arrangements intended to minimize the risk of falling overboard, and requirements to facilitate reboarding.

It describes means which can be used individually or combined to achieve these objectives, and applies to small craft of up to 24 m length of hull.

ISO 15085:2003 is not applicable to the following boat types:

  • aquatic toys;
  • canoes, kayaks, or other boats with a beam less than 1,1 m;
  • personal watercraft, covered by ISO 13590;
  • inflatable boats with a hull length of less than 8 m, covered by ISO 6185.
Table of contents
View the extract
  • Avant-propos
    v
  • Introduction
    vi
  • 1 Domaine d'application
    1
  • 2 Références normatives
    1
  • 3 Termes et définitions
    1
  • 4 Exigences générales
    4
  • 4.1 Fonctions du pont de travail
    4
  • 4.2 Moyens de protection
    4
  • 4.3 Largeur minimale des ponts
    4
  • 4.4 Continuité du pont de travail
    5
  • 5 Dispositifs de sécurité
    5
  • 6 Tableaux des exigences
    6
  • 6.1 Généralités
    6
  • 6.2 Exigences relatives aux bateaux non-voiliers
    6
  • 6.3 Exigences relatives aux voiliers
    7
  • 7 Exigences particulières pour les surfaces antidérapantes
    8
  • 7.1 Généralités
    8
  • 7.2 Exigences relatives aux trampolines et filets
    8
  • 8 Exigences relatives aux cale-pied
    9
  • 8.1 Généralités
    9
  • 8.2 Installation des cale-pied
    9
  • 8.3 Hauteur minimale et angle minimal du cale-pied
    9
  • 8.4 Cale-pied constitués de surfaces inclinées
    10
  • 8.5 Clair maximum sous un cale-pied, entre le pont et le cale-pied
    10
  • 8.6 Continuité du pont de travail à proximité du cale-pied
    10
  • 8.7 Interruptions dans la continuité du cale-pied
    11
  • 9 Exigences relatives aux prises de main
    11
  • 9.1 Généralités
    11
  • 9.2 Emplacement au niveau des ponts latéraux
    11
  • 9.3 Résistance
    11
  • 10 Exigences communes aux garde-corps et filières hauts et bas
    12
  • 10.1 Généralités
    12
  • 10.2 Hauteur des garde-corps et filières
    12
  • 10.3 Lignes intermédiaires, espacement vertical et écart maximal
    13
  • 10.4 Risque de chute d'homme à la mer à partir de zones situées en hauteur
    14
  • 10.5 Ouvertures dans les garde-corpslfilières
    14
  • 10.6 Balcons d'étrave pour voiliers
    14
  • 10.7 Garde-corps/filières arrière pour voiliers
    16
  • 10.8 Bras avant des catamarans à voile
    17
  • 10.9 Coque centrale des trimarans à voile
    18
  • 11 Exigences spécifiques de résistance pour les garde-corps et garde-corps bas
    18
  • 12 Exigences particulières relatives aux filières
    18
  • 12.1 Exigences relatives aux filières hautes, basses et intermédiaires
    18
  • 12.2 Exigences relatives aux chandeliers et aux supports de filières
    18
  • 12.3 Exigences relatives aux points d'accrochage (de harnais)
    19
  • 13.1 Généralités
    19
  • 13.2 Emplacement
    19
  • 13.3 Taille
    19
  • 13.4 Résistance
    20
  • 14 Points d'ancrage pour les lignes de vie
    20
  • 14.1 Généralités
    20
  • 14.2 Installation
    20
  • 14.3 Résistance
    20
  • 15 Maintien du corps sur les bateaux rapides
    20
  • 15.1 Généralités
    20
  • 15.2 Appui-corps
    21
  • 16 Moyens de remontée à bord
    21
  • 17 Manuel du propriétaire
    21
  • Bibliographie
    22
Need to identify, monitor and decipher standards?

COBAZ is the simple and effective solution to meet the normative needs related to your activity, in France and abroad.

Available by subscription, CObaz is THE modular solution to compose according to your needs today and tomorrow. Quickly discover CObaz!

Request your free, no-obligation live demo

I discover COBAZ