ASTM A1016/A1016M-18
1.1 This specification covers a group of requirements that, unless otherwise specified in an individual specification, shall apply to the ASTM product specifications noted below.
| Title of Specification | ASTM |
|
|
|
| Seamless Carbon-Molybdenum Alloy-Steel Boiler and | A209/A209M |
| Seamless Ferritic and Austenitic Alloy-Steel Boiler, Superheater, | A213/A213M |
| Welded Austenitic Steel Boiler, Superheater, Heat-Exchanger, | A249/A249M |
| Electric-Resistance-Welded Ferritic Alloy-Steel Boiler and | A250/A250M |
| Seamless and Welded Ferritic and Martensitic Stainless Steel | A268/A268M |
| Seamless and Welded Austenitic Stainless Steel Tubing for | A269/A269M |
| Seamless and Welded Austenitic and Ferritic/Austenitic | A270/A270M |
| Seamless and Welded Carbon and Alloy-Steel Tubes for | A334/A334M |
| Welded Austenitic Stainless Steel Feedwater Heater Tubes | A688/A688M |
| Austenitic Stainless Steel Tubing for Breeder Reactor Core | A771/A771M |
| Seamless and Welded Ferritic/Austenitic Stainless Steel Tubing | A789/A789M |
| Seamless and Welded Ferritic Stainless Steel Feedwater Heater | A803/A803M |
| Seamless Austenitic and Martensitic Stainless Steel Duct | A826/A826M |
| High-Frequency Induction Welded, Unannealed, Austenitic | A851 |
| Welded Austenitic Alloy Steel Boiler, Superheater, Condenser, | A1098/A1098M |
(A) These designations refer to the latest issue of the respective specifications.
1.2 In the case of conflict between a requirement of a product specification and a requirement of this general requirements specification, the product specification shall prevail. In the case of conflict between a requirement of the product specification or a requirement of this general requirements specification and a more stringent requirement of the purchase order, the purchase order shall prevail.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units shall apply unless the “M” designation (SI) of the product specification is specified in the order.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
