NF EN ISO 10619-1

<p> La présente Norme internationale spécifie deux méthodes de détermination du comportement des tuyaux et tubes en caoutchouc ou en plastique lorsqu'ils sont courbés selon un rayon donné. La méthode A convient pour des tuyaux et tubes de diamètre intérieur inférieur ou égal à environ 80 mm; la taille de l'appareillage d'essai pour les tuyaux et tubes de dimensions supérieures devient excessive. Cette méthode permet également de mesurer la force requise pour obtenir un rayon de courbure donné, et l'essai peut être effectué à une pression interne donnée. Avec la méthode B, les caractéristiques de courbure, y compris la force requise pour obtenir la courbure, peuvent être déterminées dans une plage de températures allant de - 60 °C à + 200 °C. Cependant, du fait de sa nature, l'appareillage ne peut être utilisé que pour des tuyaux et tubes de faible diamètre intérieur, jusqu'à environ 12,5 mm. </p>

<p>ISO 10619-1:2017 specifies three methods for measuring the flexibility of rubber and plastics hoses and tubing (methods A1, B and C1), where the deformation of the hose or tubing is measured, and two methods for measuring the stiffness (methods A2 and C2) by measuring the force required to bend rubber or plastics hoses or tubing to a specific radius at ambient temperature.</p> <p>Methods A1 and A2 are suitable for rubber and plastics hoses and tubing with inside diameter of up to and including 80 mm.</p> <p>Method A1 allows the measurement of the flexibility of the hose or tubing by measuring the reduction in outside diameter when the hose is compressed between two plates.</p> <p>Method A2 provides a means of measuring the force required to reach a specific bend radius when the hose or tubing is compressed, as between two plates. The test can be carried out at a specified internal pressure.</p> <p>Method B is suitable for rubber and plastics hoses and tubing with inside diameter of up to and including 100 mm, and provides a means of assessing the behaviour of the hose and tubing when bent around a mandrel. The final mandrel diameter used can be taken as the minimum bend radius of the hose or tubing. As this value is determined by the reduction of the outside diameter, it can be used as a measure of the flexibility of the hose or tubing. The hose or tubing being tested can be unpressurized, pressurized or under vacuum and, if required, with the curvature or against the curvature of the hose or tubing, if such curvature is present.</p> <p>Methods C1 and C2 are suitable for rubber and plastics hoses and tubing with inside diameter of 100 mm and greater.</p> <p>Method C1 provides a means of determining the flexibility of the hose and tubing at the minimum bend radius.</p> <p>Method C2 provides a method of measuring the stiffness of the hose and tubing at the minimum bend radius.</p>