NF EN ISO 14554-1

<p>ISO 14554-1:2013 specifies requirements for the demonstration of the capability of a manufacturer or a sub-contractor to produce welded constructions, fulfilling specified quality requirements, in one or more of the following: a) a contract between involved parties; b) an application standard; c) a regulatory requirement.</p> <p>The requirements contained within ISO 14554-1:2013 can be adopted in full or can be selectively deleted by the manufacturer if not applicable to the construction concerned. They provide a flexible framework for the control of welding by providing specific requirements for: 1) Case 1 ? resistance welding in contracts which require the manufacturer or sub-contractor to have a quality system in accordance with ISO 9001; 2) Case 2 ? resistance welding in contracts which require the manufacturer or sub-contractor to have a quality system other than ISO 9001; 3) Case 3 ? resistance welding as guidance to a manufacturer or sub-contractor developing a quality system; 4) Case 4 ? references in application standards which use resistance welding as part of their requirements or in a contract between relevant parties, although it is more appropriate for ISO 14554‑2 to be used in such cases.</p> <p>ISO 14554-1:2013: i) is independent of the type of welded construction to be manufactured; ii) defines quality requirements for welding both in production plants and on site; iii) provides guidance for describing the capability of a manufacturer to produce welded constructions to meet specified requirements; iv) can also be used as a basis for assessing the manufacturer in respect to his welding capability.</p> <p>For general guidelines for selection and use, see ISO 3834‑1, while being aware that only comprehensive and elementary quality requirements are specified for resistance welding. An annex gives a summary comparison of specific quality requirements for resistance welding in ISO 14554-1:2013 and ISO 14554‑2.</p>