IEC 62040-2:2005

Applies to single UPS units or UPS systems comprising a number of interconnected UPS and associated control/switchgear forming a single power system, intended to be installed in any operator accessible area or in separated electrical locations, connected to either industrial or public low voltage supply networks. Takes precedence over all aspects of the generic standards, and no additional testing is necessary. Takes into account differing test conditions necessary to encompass the range of physical sizes and power ratings of UPS. A UPS unit or system shall meet the relevant requirements of this standard as a stand-alone product. Special installation environments are not covered, nor are fault conditions of UPS taken into account. This standard does not cover d.c. supplied electronic ballast (IEC 60924 and IEC 60925) or UPS based on rotating machines. States EMC requirements, test methods, minimum performance levels.

IEC 62040-2:2016 is a type test product standard for electromagnetic compatibility (EMC) and applies to movable, stationary, fixed or built-in, pluggable and permanently connected UPS for use in low-voltage distribution systems with an environment being either residential, commercial, light industrial or industrial, which deliver output voltage with port voltages not exceeding 1 500 V DC or 1 000 V AC and which include an energy storage device. This edition includes the following significant technical changes with respect to the previous edition: a) the inclusion of network port limits in Table 1, Table 2 and Annex C for the sake of consistency with other standards; b) a change of quasi-peak limit for category C3 UPS in Table 2 for the sake of consistency with other standards; c) a clarification in Table 4 about the performance criteria for immunity tests; d) a revision of some test configurations in Annex A. The contents of the Interpretation sheet 1 of June 2018 have been included in this copy.